Hörmann HSM2 / HSM4 / HS1 / HS2 / HS4 / HSE2 / HSD2 / HSP4 / HSZ1 / HSZ2 compatible hand transmitters, clone remote controls, 868.3 MHz. (Not compatible with BS BiSecur remote controls) 

Duplicates your Hörmann 868.3 MHz remote control: HSM2 868 (blue buttons) / HSM4 868 (blue buttons) / HSZ1 868 / HSZ2 868 / HS1 868 (blue buttons) / HS2 868 (blue buttons) / HS4 868 (blue buttons) HSE2 868 (blue buttons) / HSP4 868 (black buttons) / HSD2 868 (not compatible with Hörmann BS BiSecur remote controls).

Small and compact design with sliding lid.

Fast cloning process. Clones within 10 seconds.

Battery, key ring and programming instructions (German and English) included

Distance: Extra long range. Up to 100 m. Better quality than original Hörmann remote control.

High-quality clone remote controls for Hörmann 868.3 MHz, clones your Hörmann remote control 868.3 MHz with blue buttons. Pack of 5. Duplicates your Hörmann remote control: HSM2 868 (blue buttons) / HSM4 868 (blue buttons) / HSZ1 868 / HSZ2 868 / HS1 868 (blue buttons) / HS2 868 (blue buttons) / HS4 868 (blue buttons) / HSE2 866. 8 (blue ta8 en) / HSP4 868 (black buttons) / HSD2 868. Note: Not compatible with Hörmann BS BiSecur remote controls. Technical data: Frequency: 868.3 MHz (learning code) buttons / commands: 4 (up to 4 different drives) battery, key fob and programming instructions (German and English) included; remote control: first you need to delete the remote control: 1) Hold down the LOCK and UNLOCK buttons together - LED flashes three times. 2) Hold down the LOCK button and press the UNLOCK button three times. LED starts flashing continuously. The clone remote is erased and ready to clone. Then you need to clone your original remote control: 1) Place the two remote controls side by side or in a row (II). Make sure you have contact with each other and touch each other. 2) Press and hold a button on your original remote and one button on your clone remote. Press and hold both buttons until LED: 2 x flashes > 3 x flashes > is permanently on = It has not been successfully cloned until the light remains on permanently. If the cloning process does not continue after 2 flashes, this means that the signal does not go through. Please slowly move the remote up and down until you reach the point where it passes. Note: You do not need access to control panel or radio receiver.