HVAC Heater Blend Door Actuator Gear Kit 68214880AA for Dodge Durango Jeep Grand Cherokee 2011-2017

Perfect to replace worn out, damaged or broken parts. %100 Brand new, unopened and undamaged item in original retail packaging.
Note: Please compare your parts with the pictures before purchasing an item.
Material: Hardened Plastic
Package Included: 1x HVAC Heater Blend Door Actuator Gear Kit
Compatibility:
Dodge Durango 2011-2021
Jeep Grand Cherokee 2011-2021
OEM Numbers (Only for comparison): 68214880AA


Features:

Direct Replacement!!
100% Brand New And High Quality

High Performance With Fast Shipping

 

Other Part Number:

5143199AA

 

Fit for:

2011 Dodge Durango

2011 Jeep Grand Cherokee

2012 Dodge Durango

2012 Jeep Grand Cherokee

2013 Dodge Durango

2013 Jeep Grand Cherokee

2014 Dodge Durango

2014 Jeep Grand Cherokee

2015 Dodge Durango

2015 Jeep Grand Cherokee

2016 Dodge Durango

2016 Jeep Grand Cherokee

2017 Dodge Durango

2017 Jeep Grand Cherokee

 

Package: 2x HVAC Air Door Actuator

 

 

 

Installation Guide:

1. Position the recirculation door actuator (3) to the passenger side of the HVAC housing (4) and connect the wire harness connector (1) to the actuator.2. Install the recirculation door actuator onto the HVAC housing. If necessary, rotate the actuator slightly to align the spline on the actuator with therecirculation-air door.3. Install the two screws (2) that secure the recirculation door actuator to the HVAC housing. Tighten the screws to 2 Nm (17 in. lbs.).

4. Install the blower motor .

5. Install the glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument Panel Glove Box -Installation.6. Reconnect the negative battery cable.

6. Reconnect the negative battery cable.

7. Initiate the Actuator Calibration function using a scan tool.

 

 

(1)Position the rear recirculation door actuator

(2) to the left side of the rear evaporator housing

(3) on top of the vehicle and connect the wire harnessconnector

(4) to the actuator

 

 

 

 

 

 

 


Introduction:

In some automobiles made prior to the 1980s, the blend door may have been actuated by a metal cable that was connected directly to the temperature control lever on the dashboard. A sure way to move the blend door, some systems took more than a little effort to operate. As autos had more and more labor-saving devices added as standard equipment, heater and air conditioning controls could be operated with less effort when automakers started installing blend door actuators. An actuator moves the blend door automatically when the temperature control is moved. An actuator can be powered by vacuum or by a small motor mounted within the heat and air assembly.