5.0 Liter Jaguar / Land Rover Supercharger Rebuild Kit

Needle Bearing Tool Kit

2010-2014 5.0 Only - See Compatibility


2010-2013 All with the Vacuum Actuator - 47mm 

2014 All with Electronic Actuator

2015-2016  verify its 47mm or 49mm by taking supercharger apart


GENUINE EATON PARTS

Eaton is the manufacturer of the Supercharger

  • EATON Supercharger Snout Bearings (qty 2)
  • EATON Supercharger Inlet Needle Bearings (qty 2)
  • Aftermarket PEEK 47mm Aftermarket Replacement Isolator
  • Eaton Supercharger Oil 8 oz (5.1 oz required)
  • Eaton OEM Drive Hubs
  • Eaton OEM Drain Plug
  • Syringe and tub to assist removing oil & refilling
  • Anaerobic sealer to seal the rear rotor pack cover

You need RTV to seal the snout to the supercharger! (not included)



Does not fit 3.0 liter engines


Installation Notes:

The snout is sealed to the supercharger with RTV (silicone), scrap off the old and apply some new sparingly. There is one bolt in the snout inlet on some superchargers, see 2nd picture. The TB gasket is reusable but a new one is C2Z28265. I recommend a bolt torque of 19 ft-lb for the snout bolts.


You need RTV to seal the snout to the supercharger! (not included)


Supercharger Tear Down

youtu.be/BF9o6L_qd9E


Needle Bearing Install

youtu.be/122i15j3OK8