Symetrix XIN 4 Audio Input Expander for Symetrix Systems 4 Mic or Line Level

The cost effective xIn 4 increases a system’s analog input channel capacity resulting in a reduction in overall price per channel. Designed exclusively for use with Dante-enabled Symetrix DSP units, each of the four analog inputs’ parameters (5 gain levels, phantom power), along with bus assignments, are configured using Symetrix Composer open architecture software. xIn 4 set up is logical and fast with no requirement

to use third-party software; there are no mechanical switches or circuit board jumpers to set. Systems are simpler, cost less, and have fewer potential points of failure. A half-rack form factor conserves rack space. Optional 1U rack tray and 1/2U surface mount bracket are available for separate purchase.

Features:

• Audio input (A/D) expander for Symetrix systems that capitalizes on the surplus DSP of a Dante enabled Symetrix DSP unit to bring overall system costs down.
• 4 mic/line inputs, including +48 VDC phantom power, with the industry leading performance specifications of Radius, Edge, and Prism DSPs.
• Configured with Symetrix Composer. No third-party software, archaic DIP switches, or complicated front panel menus.
• Network audio expansion using Dante protocol over standard IT networks. Ultra-low latency.
• PoE Injector included.
• Optional 1U rack tray and 1/2U surface mount bracket available for separate purchase

 

Specifications:

Electrical Specifications

ANALOG INPUTS

Frequency Response: 20 Hz – 20 kHz, ± 0.5 dB.

Channel Separation: > 111 dB @ 1 kHz, +24 dBu.

Connectors: 3.5 mm Phoenix® connectors.

Number of Inputs: Four (4) switchable balanced mic or line level.

Nominal Input Level: +4 dBu with 20 dB of headroom.

Maximum Input Level: +23 dBu.

Mic pre-amp gain: 0, 11.8, 24, 44 or 54 dB switchable.

Mic pre-amp EIN: < -127dB with 150 ohm source impedance.

CMRR: > 76 dB @ 1 kHz, unity gain.

Input impedance: 8k Ohms balanced, 4k Ohms unbalanced.

Phantom power (per input): +48 VDC @ 10 mA maximum.

Dynamic range: > 116 dB, A-weighted.

THD + Noise: < -100 dB, unweighted; 1 kHz @ +22 dBu with 0 dB gain.

Latency: 0.28 mS.

SYSTEM

Sampling Rate: 48 kHz, ± 100 ppm.

Dante Cable: Standard CAT6, maximum device-to-device length = 100 meter