BioGuard Power-Floc restores water sparkle by floccing (sinking to the bottom) suspended particles that may cause cloudy or dull water. Power-Floc works overnight settling dead algae and suspended particles to the bottom of the pool so they can be vacuumed out to waste.
Product Benefits:
- Clears heavily clouded pools
- Restores water sparkle
- Highly concentrated
- Contains no metals
- Easy to use (no mixing)
- Works with all types of pools & filters
- Does not effect water balance
Directions:
- Shake well before using
- Clean skimmer, hair and lint pot, and backwash filter
- Adjust pH to 7.5 to 8.0 for best results
- Apply at a rate of 8 oz. per 10,000 gallons. For extremely cloudy pools use double the normal dosage
- Remove any chemical products from skimmer basket
Usage with Sand Filters:
- With pump on and filter valve on Recirculate, pour Power-Floc slowly into skimmer
- For sand filters without a Recirculate option - clean filter and pour Power-Floc into a large pail of water (dilution of 8 oz. per 1 gallon of water) and apply solution evenly over the surface of the pool
Usage with Cartridge Filters:
- Remove cartridge filter element from filter tank
- Reassemble filter tank without filter element
- With pump on, pour Power-Floc slowly into skimmer
- Allow pump to circulate for 2 hours then turn pump off
- 12-24 hours later, slowly vacuum to waste (Do not vacuum debris through filter)
- Backwash filter and clean filter with Strip Kwik then resume normal filter cycle
- Check pH and readjust, if needed, to 7.2-7.6