HRC45 Solid Carbide Chamfer End Mill Cutter 1mm-12mm - 60° Degree AlTiN coating
WARNING: Solid carbide chamfer mills are not recommended for manual milling, especially on low rigidity benchtop mills. Being so hard and rigid they are much less forgiving on chatter/backlash compared to HSS or an indexed carbide chamfer. For manual mills please consider INDEXABLE CARBIDE CHAMFER MILL or HSS CHAMFER MILLS. Mills are ungashed so unsuitable for spot drilling. For spot drilling chamfers please see SOLID CARBIDE SPOT DRILLS. Geometry is optimized for steel cutting, not non-ferrous. AlTiN coating will react with aluminium so not recommended, use uncoated or coatings not including aluminium.
Recommended Spindle Runout - 5 microns or less. Maximum Runout - 20 microns. Tool lifespan at 20 microns is 80% lower than at 2 microns.
Description:
These high-quality chamfer end mills are made from solid carbide and feature a 60 degree chamfer angle for precise and efficient cutting. A 60 degree chamfer angle is commonly used for creating a beveled edge or chamfer on a workpiece. A chamfered edge is typically used to remove sharp corners or edges, to allow easier insertion of a mating part, to prevent stress concentration or to improve the aesthetic appearance of the workpiece. It can also create a chamfered edge on the workpiece, which can be useful for deburring or edge-breaking applications.
Material : Tungsten Carbide
Coating : AlTiN
HRC : 45
Chamfering Angle : 60 Degrees
Sizes give as Cutting Tip Diameter x Shank Diameter x Length:
1mm x 4mm(d) x 50mm - 2 flute
1.5mm x 4mm(d) x 50mm - 2 flute
2mm x 4mm(d) x 50mm - 2 flute
3mm x 3mm(d) x 50mm - 3 flute
4mm x 4mm(d) x 50mm - 3 flute
5mm x 5mm(d) x 50mm - 3 flute
6mm x 6mm(d) x 50mm - 3 flute
8mm x 8mm(d) x 60mm - 3 flute
10mm x 10mm(d) x 75mm - 3 flute
12mm x 12mm(d) x 75mm - 3 flute
OTHER MILLING CUTTERS
60 Day No Quibble Returns Policy
If for any reason you are unhappy with your order please initiate a returns request through eBay within 60 days for a full refund.