The FemtoJet enables minute quantities of liquid to be injected into cells. The relevant parameters (injection pressure p_i and injection time t_i ) are set using the variable regulators. The key or connected hand or foot control (not included) or the INJECT key of the connected micromanipulator are used to trigger these two parameters. If no injections are being performed, compensation pressure p_c is applied permanently

Voltage/Frequency: 100 V – 240 V ± 10 %, 50 – 60 Hz 

Set voltage: adapts automatically 

Fuse for 100 – 240 V: T1.0 A, 250 V (2 pcs.) 

Power consumption: 50 W 

Max. current consumption: < 0.5 A 

Protection class: I 

Overvoltage category: II (IEC 61010-1) 

Pollution degree: 2 (IEC 664) 

Ambient temperature: 15 °C – 35 °C 

Ambient relative humidity: max. 70 % 

Weight: 6.2 kg 

Dimensions: Width: 220 mm Depth: 170 mm Height: 280 mm 

Injection time t_i : 0.0 – 99.9 s in 0.1 s increments 

Injection pressure p_i : 0 – 6,000 hPa (87 psi), in 1 hPa (0.01–0.02 psi) increments 

Regulating accuracy: 1 % of value set in each case, at least ± 1 hPa 

Compensation pressure p_c: 0 – 6,000 hPa (87 psi), in 1 hPa (0.01–0.02 psi) increments 

Regulating accuracy: 1 % of value set in each case, at least ± 1 hPa 

Clean rinsing pressure: max. approx. 7,000 hPa (102 psi) 

RS 232 computer Baud rate: 9,600 interface: Start bit: 1 Data bits: 8 Parity: non Stop bit: 1