Tub Repair Kit

Easy Homeowner Patch Kit

  1. Drill a small hole at each end of the crack to stop it from spreading
  2. Sand the area to be patched                                                                   
   3. Clean the area to be patched and let dry                                               
   4. Cut the patch with a pair of scissors 2" longer then the crack            
    5. Apply the patch. Rub real hard. Use a hair dryer on low Just warm it
    6. let sit for at least 12 hours prior to use                                                   
    7. Place a bath mat over the patched area                                                  


Please look at all the photos.

Try not to step on the area of the crack or take a bath with a patched tub

The goal here is to stop the leaking until the tub can be replaced   

This is not intended to be a pretty or permanent repair but it will
stop the leaking until the tub can be replaced.

If the crack is longer than 6 inches or is located around the drain
we do not advise using this patch.

Patch, drill bit, sand paper & alcohol wipe included

If you are going to place an order please print out these instructions.

Thanks for looking!!