Operation:
- Take out the parts and place the suction cup (7) onto the clean glass of the window.
- Extend the wire antenna loop of the amplifier (2) by using the extension rod (6), then hang it on the hook of the suction cup or fasten it to the curtain using the clip (8).
- Insert two batteries (AAA, UM4) into the control box (1) and close the battery cover. Place it beside your radio, plug one end of the cable (5) into the amplifier and the other end into the control box.
- Select your desired band from the amplifier, then push the “POWER” switch of the control box to “ON” position; the power indicator LED turns green.
For SW:
If your radio has an SW antenna input jack, connect the 3.5mm plug of the control box into it; if not, then connect the 3.5mm plug of the control box into the black and red connector clips (4). Fasten the red clip to the telescopic antenna of the radio and the black clip to a self-made grounding line.
If your radio has an MW antenna input jack, connect the 3.5mm plug of the control box into it; if not, then connect the 3.5mm plug of the control box to the ferrite bar antenna coupler (3) and place it near the built-in MW antenna of the radio. For pocket sized radios, you can use the base station (9) to keep the ferrite bar antenna coupler near the MW antenna.
Dial the “TUNING” knob of the control box up/down for better signal reception.
Dial the “LEVEL CONTROL“ knob of the control box up/down if the radio signal is too strong and causes a distorted sound.