|
- Arduino Compatible!
- This is the new APM 2.6 module.
The sensors are exactly the same as with APM2.5+, however this version does not
have an onboard compass, which makes this version ideal for use with
multicopters and rovers.
- Can be ordered with top entry pins for
attaching connectors vertically, or as side entry pins to slide your connectors
in to either end horizontally
- Includes 3-axis gyro, accelerometer and
magnetometer, along with a high-performance barometer
- Onboard 4 MegaByte Dataflash chip for
automatic datalogging
- Optional off-board GPS, uBlox NEO-6M module with Compass.
- One of the first open source autopilot
systems to use Invensense's 6 DoF Accelerometer/Gyro MPU-6000.
- Barometric pressure sensor upgraded to
MS5611-01BA03, from Measurement Specialties.
- Atmel's ATMEGA2560 and ATMEGA32U-2 chips for processing and usb functions
respectively.
- GPS Features: Built-in compass GPS module
Main chip: Ublox-6M With
fast satellite searching speed and high precision Compatible with APM serial
port and I2C port
Includes round plastic shell and GPS support.
- The APM 2.6 is a complete open source
autopilot system and the bestselling technology that won the prestigious 2012
Outback Challenge UAV competition. It allows the user to turn any fixed, rotary
wing or multirotor vehicle (even cars and boats) into a fully autonomous
vehicle; capable of performing programmed GPS missions with waypoints.
Available with top or side connectors.
- This flight controller needs customers
having rich experience and great patience in tuning and using it, it is not
suggested for new beginners.
TTL 3DR Radio 3DRobotics Telemetry 433Mhz module (433MHz):
- 433-434.79MHz
- Light weight (under 4 grams without antenna)
- Receiver sensitivity to -121 dBm
- Transmit power up to 20dBm (100mW)
- Transparent serial link
- Air data rates up to 250kbps
- MAVLink protocol framing and status reporting
- Frequency hopping spread spectrum (FHSS)
- Adaptive time division multiplexing (TDM)
- Support for LBT and AFA
- Configurable duty cycle
- Built in error correcting code (can correct up to 25% data bit errors)
- Demonstrated range of several kilometers with a small omni antenna
- Can be used with a bi-directional amplifier for even more range
- Open source firmware
- AT commands for radio configuration
- RT commands for remote radio configuration
- Adaptive flow control when used with APM
- Based on HM-TRP radio modules, with Si1000 8051 micro-controller and Si4432 radio module
- Very small size
MAVLink-OSD:
Introduction
- MAVLink-OSD is an Arduino based project and it is fully compatible with original MinimOSD.
- This board can be used for CRIUS AIOP and Arduflyer / ArduPilot-Mega.
- MAVLink-OSD with switching DC/DC stepdown powersupply to maximize efficiency on power system. No more heating problems when using this OSD board.
- Default OSD Firmware is MinimOSD-Extra, written by Gábor Zoltán.
- About how to use the configurator tool to setup OSD function: Click here
- How to setup hardware (original MinimOSD Wiki): click here
Features
- ATMEGA328P Microcontroller
- MAX7456-EUI monochrome on-screen display
- 5V/500mA DC/DC regulator for MAX7456-EUI
- Operating voltage: 5V(FTDI connector) and 12V(Video I/O connector)
- Supported NTSC & PAL
- FTDI connector
- Full MAVLink protocol support
- Graphical configurator tool
APM Power Module：
Introduction:
Power Module is a simple way of providing your APM/Arduflyer with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6P cable.
The on-board switching regulator outputs 5.3V and a maximum of 3A from up to a 7S LiPo battery.
Features:
- Voltage and current measurement configured for 5V ADC
- Max input voltage: 30V
- Max current sensing: 90A
- Switching regulator outputs 5.3V and 3A max
- 6P molex cable plugs directly to APM/Arduflyer 2.5's 'PM' connector
- Dimension(mm): 25 x 21 x 9
Note: The Power Module is only designed to power APM/Arduflyer, a RC receiver and accessories (GPS, Radio telemetry).
It is not designed to power servos. Use your aircraft's own ESC/BEC for that.
Package Content：
- 1 x APM 2.6 Board with Shell
- 1 x Ublox-6M GPS module (include Roud plastic shell and GPS folding support)
- 1 x TTL 3DR Radio 3DRobotics Telemetry 433Mhz kit
- 1 x MAVLink-OSD
- 1 x Power Module
- 1 x Shock Absorber Plate
- 1 x cable set
|
