Introduction

Xilinx Spartan-3 XC3S200 FPGA module is a low cost and easy to use tool. Designed for rapid prototyping and implementing FPGA designs. Module can be used for educational purposes. This module has all needed components to be used independently, and at the same time, designed to be used as core module for bigger design.

Features

1) Xilinx XC3S200 FT256 FPGA

*         200,000-gates (4,320 Logic Cells)

*         12x 18x18 hardware multipliers

*         12x 18K-bits block RAMs (216K)

*         4 Digital Clock Managers

*         Fully supported by latest XILINX design tools

2) Xilinx XCF01S VO20C Flash

*         1 Mbit Platform Flash PROM

*         IEEE Standard 1149.1/1532 Boundary-Scan (JTAG) support for programming

*         Endurance of 20000 Program/Erase Cycles

*         Fully supported by latest XILINX design tools

3)      Crystal oscillator

*         Oscillators with different frequencies available

4)      Four IO LEDs

5)      Two IO push buttons

6)      JTAG header connected to JTAG chain

*         FPGA

*         FLASH

7)      Mode select jumper

*         JTAG

*         FLASH

8)      Push button for manual initiation of configuration process

9)      Reset supervision

*         LM809

10)   Onboard power supply

*          3.3V

*          2.5v

*          1.2v

*         Input voltage range 4.5V – 15V. (5V recommended)

11)   Power-ON LED

12)   DONE LED

13)   90 independent I/O routed to the connectors

*         4x 19 pin line male connectors (18 IO + 1 power)

*         One standard 20-pin connector (18 IO + 2 power)

*         2.54mm pitch for all connectors

14) Small 50x50mm PCB designed to fit on the prototyping board with 2.54mm pitch

You can download schematics, user's guide, demo code bitstream, and source code from here:

http://sdrv.ms/1hlM9dj

Project created with ISE 14.1

PCB dimensions:

http://sdrv.ms/17Rvj5i

Standard traceable shipping worldwide. Within European Union, most of the packages are delivered in 3-6 work days.

By default module will have 62.500 MHz oscillator, but you can ask for other oscillator frequency:

10mhz (5pcs left)
33.33mhz (4pcs left)
133mhz (1pcs left)

Add message to me during check out, or send email, if you want any of these oscillators to be on your module instead of 62.500 MHz

This particular module has "XC3S200 FT256 4C" FPGA IC.

You can ask, if you want to customize LEDs, connectors or oscillator (add/remove/different type)

You can also buy cheap JTAG cable for this module.

Check my other auctions