Item:

Pro Touch Off Gage (Model: 04-000)

Condition:

New in Box

Specifications

• Large 2.2 in easy to read indicator face

• Large 1 in diameter contact face allows all flutes of the tool to make contact for the most accurate measurement

• Contact face is lightly spring loaded to protect against overrun

• Contact face is made from hard anodized aluminum ensuring no damage will come to expensive end mills. Replacement contact face is field replicable with a low cost of $4.99.

• Body made from red anodized 6061-T6 aluminum

• Offset height 4.000 in (101.6mm)

• Easy calibration using 1-2-3 blocks

• Gage repeatability 0.0002 in

• Padded case included

Pro Touch Off Gage

Set tools like a pro with the new Pro Touch Off Gage by Edge Technology Products. Dramatically decrease set up time and eliminate tool path mismatch. The Pro Touch Off Gage allows you to standardize the way tool offsets are measured in your shop. Ensuring every job is setup the same way and runs without issue. To use this gage just lower the tool down onto the contact face until the indicator reads zero, at that point you can be confident that the tool tip is exactly 4 inches from the surface the Pro Touch Off Gage is sitting on. Buy one today and start setting your tools like a pro!

The Pro Touch Off Gage is CNC machined to exacting tolerances from 6061-T6 aluminum. The Body is hard red anodized to resist wear and provide years of service.

Payments Accepted:

Paypal

Shipping

International:

Email

info@edgetechnologyproducts.com

Phone

(520)-299-1185