USB interface relay module. USB adapter plus the relay module.
Can interface with PC over USB
directly(1). Activated by UART RTS assertion, turn on by invoking any terminal software and turn off by leaving it.
directly(1). Activated by UART RTS assertion, turn on by invoking any terminal software and turn off by leaving it.If more robust relay ON/OFF triggering is desired, please consider 
. It will change state upon receiving command code instead of a pin state.
. It will change state upon receiving command code instead of a pin state.Using PL2303H chip. Work with multiple OSs including MS Windows XP.
Features:
Remarks:
- Approximately 0.8m long cable.
- Four dupond connectors, 2.54mm pitch type. 5V, Rx, RTS and GND. Powered by the USB host. LV-TTL I/O voltage level.
- Supports baud rate from 75 to 128000.
- Intended for working with the relay module.
- Relay module: 51mm x 25mm x 20mm.
- TTL 5V high level triggered ON.
- Power rating: 10A 250VAC, 10A 125VAC; 10A 30VDC; 10A 28VDC.
- USB to TTL level adapter.
- Single way SPDT relay module.
Remarks:
- The 5V is just a voltage reference. Please assume it can NOT power up your board except the verified relay module board.
- Win 7 is not supported.
Payment:
- Only accept Paypal.
- Please pay within 3 days after invoice sent.
Shipping:
- The item will be shipped by HK post registered airmail within three business days (GMT+8) after payment has been received. Shipping time will vary among different countries. Delay may be caused by the custom of your local country. Don't leave negative feedback due to shipping time. Only EMS can guarantee, please request for an EMS quote before bidding.
Technical support:
- URL for the driver and color definition for the wires would be provided.
Refund:
- Each cable has been tested before shipping. It is a non-fool proof device, placing the GND pin to the VDD of the target board will burn the pl2303 right away. Sorry, NO refund for any defective item.