PROGRAMMING 

o    1 Open your driver's side door and get into the vehicle. Leave the door open. Put your key into the ignition and turn it to the "On" position.

o    2 Push the "Valet" button on the remote one time to program your alarm, two times to program the trunk release and door locks, and three times to program the remote starter.

o    3 Listen for one, two or three chirps from the system, according to which function you are programming from the previous step. 

o    4 Push and hold the "Valet" button and then push the button for the feature you want to program.

o    5 Listen for one, two, or three chirps to confirm programming. Press the "Valet" button to exit programming mode. Turn your ignition key to the "Off" position.

OR

                   1) Open a door and make sure the dome light is on.
    
                  2) Turn the ignition on to the RUN position or you may also start car.

               3) Within 15 seconds press and release the Valet/Program push button
               to select the channel you wish to program. For example, press and release
              once for channel 1 (arm/disarm channel).
             For Channel 2, press and release twice (trunk release).
            For Channel 3, press and release three times (remote start).
           (Some DEI systems require different programming for different channels. You
          can get specific installation manuals with remote programming instruction Here)
      
         Press and hold the Valet/Program push button once more. You should get a
          confirmation chirp/horn-honk or a flashing LED light (If installed).
         If you do not get a chirp/horn-honk the alarm may have a jumper in
         the alarm that has the programming feature turned OFF (disabled).

4) Once the alarm chirps/horn-honks keep holding the Valet/Program push button.

5) Press the button on the transmitter that you would like to control the selected receiver
   channel. A chirp/horn-honk will confirm that the code has been learned. If programming
   more than one transmitter repeat step 5. Old transmitter codes will be dropped only
   if programming 4 new transmitters.
    
6) Once the code(s) are learned, the Valet/Program push button can be released.

Learn Routine will be Exited if:

Ignition is turned off
Door is closed
Valet/Program push button is pressed too many times
More than 15 seconds elapses between steps
One long chirp/horn-honk indicates that Learn Routine has been exited.