6 Positions MODE SWITCH
NOW IN UNIVERSAL VERSION - FITS MOST TRANSMITTERS !*
fully compatible with Ardupilot & Arducopter
THIS IS the Ready made version: You get the switch and trimmers soldered. For the DIY Version click here
No more mixing and setting for 2\3 way switches of your radio !!!
No more hard-to-remember switch combinations !!
No more hard-to-remember switch combinations !!
The Solution
This is what you actually get:
1 fully assembled mode switch system
1 printed instructions
What else you need:
-Soldering iron
-Solder
-some basic tools (pliers, screwdriver)
* Product look and colors might change without prior notice, as we are always working to improve it !
compatible with most of the transmitters in the market. please contact if you have any issue.
We are using minimized components, but it might still not fit into the tightest of transmitters - it is your responsibility to check the available space and fit it.
* This mode switch can ONLY be used to replace a continuous know on your TX. It cannot be wired instead of a 2-way or 3-way switch !
sorry, but we can't provide further assistance regarding the installation of this item.
this listing contains clear visual guidance, that should be understandable for anyone.
No returns accepted, due to the item's nature.
- This switch is a 6 position rotary knob, that allows you to assign a flight mode on Ardupilot for each of the 6 positions.
- Easily switch between flight modes in the field, with confidence that you know your current mode !
- NEW: Allows you to set manually the exact PWM for each of the 4 middle modes ! (first and last modes will give minimum and maximum PWM)
- This switch uses accurate resistors at precise values to achieve the exact values the Ardupilot needs for keeping in the middle of a position.
- Much safer to use than a continuous knob, and much easier than combining 2 switches !
- You only need some basic soldering skills !
- this switch is made for replacing any continuous knob on your radio transmitter. (for example: 'PIT TRIM' knob on your Turnigy 9X radio.)
- installing is just as easy as opening the radio, unsoldering the old knob, and placing the new switch
- While the TX is still opened, monitor the PWM values on the Ardupilot software, and adjust the small trimmers for setting each position desired PWM value.
 |
New ADD-ON !! No more guessing ! Easily navigate and pilot while having a clear and simple indication for the current flight mode ! |
This is what you actually get:
1 fully assembled mode switch system
1 printed instructions
What else you need:
-Soldering iron
-Solder
-some basic tools (pliers, screwdriver)
* Product look and colors might change without prior notice, as we are always working to improve it !
compatible with most of the transmitters in the market. please contact if you have any issue.
We are using minimized components, but it might still not fit into the tightest of transmitters - it is your responsibility to check the available space and fit it.
* This mode switch can ONLY be used to replace a continuous know on your TX. It cannot be wired instead of a 2-way or 3-way switch !
sorry, but we can't provide further assistance regarding the installation of this item.
this listing contains clear visual guidance, that should be understandable for anyone.
No returns accepted, due to the item's nature.